水菜丽加勒比av在线播放-国产精品一区二区三区综合-国产精品一区二区久久不-欧美国产精品亚洲精品观看

當前位置:首頁-新聞中心新聞中心

通風空調管道質量通病的防治

發布人:http://hwzxw.net   發布時間:2021-08-11 16:29:39

保溫質量通病主要表現為膠水涂刷不均勻,保溫材料粘接不嚴密,保溫材料的厚度選用不正確以及外觀型式不統一,型式不美觀等。在施工中有如下幾個主要質量問題:

The common problems of thermal insulation quality mainly include uneven glue brushing, loose bonding of thermal insulation materials, incorrect selection of thickness of thermal insulation materials, inconsistent appearance type, unsightly type, etc. There are several main quality problems during construction:

(1)保溫層與木托粘接不嚴密。施工中,因工人保溫層長度測量不準確,工人施工時常將保溫材料拉長后粘接。由于材料本身有彈性,拉伸后即會收縮,時間長了,就出現了保溫材料與木托粘接處開膠的現象,這是保溫中更常見的質量問題之—。

(1) The bonding between the insulation layer and the wooden support is not tight. During construction, due to the inaccurate measurement of workers' insulation layer length, workers often stretch the insulation materials and then bond them. Due to the elasticity of the material itself, it will shrink after stretching. After a long time, the adhesive between the thermal insulation material and the wooden support will open, which is one of the most common quality problems in thermal insulation.

防治措施:在下料和粘接過程中不準拉伸材料,同時要求在木托兩側和保溫材料截面上都要涂刷膠水,膠水涂刷的要均勻飽滿;木托要選用規則的,如果木托斷裂成數塊,就要換掉 ,防止因冷橋產生結露現象。

Prevention measures: it is not allowed to stretch materials during blanking and bonding. At the same time, glue shall be painted on both sides of the wooden support and on the section of the thermal insulation material, and the glue shall be painted evenly and fully; The wooden support shall be regular. If the wooden support is broken into several pieces, it shall be replaced to prevent condensation due to the cold bridge.

(2)保溫材料之間粘接不嚴密。保溫材料之間的粘接比較常見,特別是在水平管上方和立管的側面保溫材料的粘接縫較長,很容易出現粘接不牢的現象。這主要是材料在切割過程中截面不平整、膠水涂刷不均勻造成的,這也是保溫中更常見的質量問題之一。

(2) The bonding between thermal insulation materials is not tight. The bonding between thermal insulation materials is common, especially above the horizontal pipe and on the side of the riser. The bonding joint of thermal insulation materials is long, which is prone to loose bonding. This is mainly caused by the uneven section and uneven glue brushing during the cutting process, which is also one of the most common quality problems in thermal insulation.

防治措施:要求施工人員在下料的過程中要使用直尺,不能徒手下料,涂刷膠水時要求均勻,粘接時要從一側開始逐步向另一側用力擠壓,保證材料的切割面都能受力粘接牢固。

Prevention and control measures: the construction personnel are required to use a ruler in the process of blanking, and the blanking shall not be done by hand. The glue shall be applied evenly, and the bonding shall be squeezed gradually from one side to the other side, so as to ensure that the cutting surface of the material can be stressed and bonded firmly.

(3)彎頭處開膠。管道保溫時一般要求把保溫層接縫放在管道上方,而在管道的彎頭上方經常出現保溫層開裂現象,致使局部保溫層過薄,造成凝結水結露。

(3) Glue shall be opened at the elbow. During pipeline insulation, it is generally required to place the joint of the insulation layer above the pipeline, and the insulation layer cracking often occurs above the elbow of the pipeline, resulting in local insulation layer being too thin and condensate condensation.

防治措施:要求施工人員在做彎頭保溫時不能只根據估計的尺寸下料,要用軟皮尺精確量取尺寸;所下料的截面要平整;在管道彎頭局部受力大的地方多涂抹膠水。

Prevention and control measures: the construction personnel are required not to cut materials only according to the estimated size when making elbow insulation, but to accurately measure the size with a soft leather ruler; The cut section shall be flat; Apply more glue where the local stress of the pipe elbow is large.

對彎頭保溫時,盡量采用直接彎管保溫,即保溫層粘接縫順著管道方向,而不采用切割馬蹄型分多次粘接來找補弧度的方法。這樣可省去大量的人力時間和材料,還能保證保溫質量,同時外觀上也較后者美觀。

For elbow insulation, direct elbow insulation shall be adopted as far as possible, that is, the bonding joint of the insulation layer shall follow the direction of the pipeline, rather than the method of cutting horseshoe type and multiple bonding to repair the radian. In this way, a lot of manpower, time and materials can be saved, the insulation quality can be guaranteed, and the appearance is more beautiful than the latter.

20170427487014.jpg

(4)穿墻套管歪斜。實際施工容易出現管道穿墻處的套管放置偏心或偏出墻體,致使保溫層不能穿過墻體,起不到保溫的作用。

(4) The through wall casing is skewed. In actual construction, it is easy to place the casing at the place where the pipeline passes through the wall eccentric or deviates from the wall, so that the thermal insulation layer cannot pass through the wall and cannot play the role of thermal insulation.

防治措施 :套管一般是直接采用施工中的管道切割制作,根據墻體厚度和抹灰厚度定出套管長度,在墻體施工前用多根楔型木條把套管支撐起來,固定在管道上,塞木條時要保證套管與管道同心。保溫施工時把木條拆下來,再將保溫層穿過套管。

Prevention and control measures: the casing is generally cut and made directly by the pipeline in construction. The length of the casing is determined according to the wall thickness and plastering thickness. Before wall construction, the casing is supported and fixed on the pipeline with multiple wedge-shaped wooden strips. When plugging the wooden strips, ensure that the casing is concentric with the pipeline. During insulation construction, remove the wooden strip, and then pass the insulation layer through the casing.

(5)成品被破壞。橡塑保溫施工完畢后,靠近人行通道的保溫管道,容易被沉重和尖銳的物體磕碰、刮破。

(5) The finished product is damaged. After the rubber and plastic insulation construction, the insulation pipeline close to the pedestrian passage is easy to be knocked and scratched by heavy and sharp objects.

防治措施 :在明裝的地方采用紙箱或厚的塑料布包裹嚴密,用鐵絲捆綁結實,施工中可以利用橡塑材料或風機盤管的包裝箱。保護層要超過普通人手所能夠到的高度。在明裝的新風機房和明裝管道井中的保溫要盡量推遲到其它工種施工完畢后再施工,爭取一次做到位。

Prevention and control measures: the exposed places shall be tightly wrapped with cartons or thick plastic cloth and firmly bound with iron wires. Rubber and plastic materials or packing boxes of fan coil units can be used in construction. The protective layer should be higher than ordinary hands can reach. The thermal insulation in the exposed fresh air fan room and exposed duct shaft shall be postponed to the construction of other types of work as far as possible, and strive to be in place at one time.

好的產品成就好的服務,好的企業成就好的產品, 濟南通風管道堅持為客戶提供的服務,詳情請繼續關注我們的網站:http://hwzxw.net

Good products make good services, and good enterprises make good products. Jinan ventilation duct insists on providing customers with high-quality services. Please continue to pay attention to our website for details: http://hwzxw.net


上一篇:通風管道的材料如何進行分類?
下一篇:清洗通風管道這些方法要用上!

網站首頁 關于我們 產品展示 新聞中心 工程案例 在線留言 聯系我們

益阳市| 云梦县| 牙克石市| 五家渠市| 启东市| 开化县| 汤原县| 清流县| 大余县| 大田县| 娄烦县| 余庆县| 九江市| 玉田县| 广水市| 石家庄市| 仁布县| 金华市| 蒲江县| 武夷山市| 内江市| 孙吴县| 宁津县| 始兴县| 宕昌县| 永和县| 连云港市| 桐柏县| 钟祥市| 乐业县| 茶陵县| 韶关市| 金乡县| 胶南市| 林口县| 额尔古纳市| 双城市| 达尔| 濮阳市| 塔河县| 丰原市|